Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max HD 1028 OHXE 38826 Operator's Manual

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 55).
Figure 55
2. Turn the base of the bulb counterclockwise until it
stops (Figure 56).
Figure 56
3. Remove the bulb straight out from the back of the
headlight (Figure 57).
Figure 57
4. Insert a new bulb into the back of the headlight
58).
5. Turn the base of the bulb clockwise until it is snug
(Figure 59).
6. Insert the wire connector straight into the back of the
headlight until it is securely in place
(Figure
25
Figure 58
Figure 59
(Figure 60).
Figure 60