Table of Contents
Advertisement
Operating the Hand Warmers
Flip the switch to the On position to turn on the hand
warmers.
Flip the switch to the Off position to turn off the hand
warmers.
Figure 33
1. On/off switch
2. On position
Operating the Traction Drive
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to Checking the Traction
Drive Operation in Setup for more information.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.
Important: To operate the traction drive, you must
operate the machine with the self-propel feature
engaged. Refer to Freewheeling or Using the Self-propel
Drive.
1. To engage the traction drive, squeeze the left hand
(traction) lever to the handgrip
3. Off position
(Figure
34).
2. To stop the traction drive, release the traction lever.
Using the Wheel Clutch Levers
The wheel clutch levers allow you to momentarily disengage
the drive to one or both wheels with the traction drive lever
still engaged. This enables you to turn and maneuver the
machine easily.
Note: Holding down the traction lever against the handle
engages the traction drive to both wheels.
To turn the machine to the right, lift up on the right wheel
clutch lever and squeeze it toward the handle
Note: This disengages the drive to the right wheel while
the left wheel continues driving, and the machine turns to
the right.
Note: Similarly, squeezing the left wheel clutch lever turns
the machine to the left.
When you complete the turn, release the wheel clutch lever,
and the drive re-engages both wheels
16
Figure 34
(Figure
Figure 35
(Figure
36).
Figure 36
35).
Hide quick links:
Advertisement
Table of Contents
