Product Overview - Toro Power Max HD 1028 OHXE 38826 Operator's Manual

3. Squeeze the left hand (traction) lever to the hand-grip
(Figure 20).
Figure 20
The machine should move rearward. If the machine
does not move or moves forward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 11).
C. Turn the trunnion downward (clockwise) on the
speed control rod
D. Connect the trunnion to the speed selector lever
(Figure 11).
4. Release the traction lever.
5. Move the speed selector to the Position F1; refer to
Operating the Speed Selector.
6. Squeeze the left hand (traction) lever to the hand-grip
(Figure 20).
The machine should move forward. If the machine
does not move or moves rearward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 11).
C. Turn the trunnion upward (counterclockwise) on
the speed control rod
D. Connect the trunnion to the speed selector lever
(Figure 11).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.
(Figure 11).
(Figure 11).

Product Overview

G016495
1. Hand-grip (2)
2. Auger/impeller lever
3. Speed selector lever
4. Quick Stick® discharge
chute control
5. Traction lever
6. Fuel tank cap
7. Engine oil fill tube/dipstick 16. Headlight
8. Chute deflector
9. Discharge chute
1
2
3
4
1. Primer
2. Ignition switch
3. Choke
4. Fuel shutoff valve
11
Figure 21
10. Scraper
11. Auger
12. Skid (2)
13. Electric starter button
14. Electric starter plug-in
15. Snow cleanout tool
17. Wheel clutch lever (2)
ST OP
G016500
Figure 22
5. Throttle
6. Oil drain plug
7. Recoil starter
5
6
7