Mk3 Fixed Cutterhead 8 Inch (20 Cm) - Toro CT2120 30655 Operator's Manual

Figure 32
WARNING
Always ensure that the grass deflectors are angled
below horizontal level, otherwise risks to health
and safety may result.
Height of cut gauge: An optional height of cut
gauge is available to assist in achieving accurate cut
height settings. It is suitable for both fixed and floating
cutterheads (Figure 33).
Figure 33
G014425
G014426
25
MK3 Fixed cutterhead 8 inch
(20 cm)
Pivot knuckle fixing: Secure the bolt in the front fixed
hole position in Figure 34 as shown.
1
Figure 34
1. Front fixed hole position
Height of cut adjustment: The height of cut is gauged
by the position of the rear roller. Turn the adjusting nut
assembly both ends clockwise to decrease height of cut
or anti-clockwise to increase height of cut (Figure 35).
2
Figure 35
1. Adjusting nut assembly
Important: Do not attempt to unlock the nut
assemblies.
Ensure that all cutterheads are set at the same height of
cut by either referring to the indicator rings (Figure 36 )
G014427
1
G014428