Mk3 Floating Cutterhead 8 Inch (20 Cm) - Toro CT2120 30655 Operator's Manual

or by using a height of cut gauge across the full width
of each cutterhead for greater accuracy as shown.
Figure 36
1. Indicator rings
MK3 Floating Cutterhead 8
inch (20 cm)
Pivot knuckle fixing: Secure the bolt in the rear
floating slot position Figure 37 as shown.
1
Figure 37
1. Rear floating slot position
Height of cut adjustment: The height of cut is
gauged by the position of the front and rear rollers.
To alter the rear roller position, turn the adjusting nut
assembly both ends clockwise to decrease height of cut
or anti-clockwise to increase height-of-cut (Figure 38).
1
=
G014429
G014430
2
3
1. Adjusting nut assembly
2. Adjusting nuts
Important: Do not attempt to unlock the nut
assemblies.
To alter the front roller position loosen bolts. Release
and turn adjusting nuts both ends clockwise to increase
the height of cut or anti-clockwise to decrease the
height of cut (Figure 39).
1
1. Height-of-cut
2. Equal
Ensure that all cutterheads are set at the same height of
cut by referring to the indicator ring sor use the height
of cut gauge across the full width of each cutterhead as
shown (Figure 39) .
Tighten nuts on both ends.
26
1
4
G014431
Figure 38
3. Height-of-cut
4. Indicator rings
2 3
=
Figure 39
3. Indicator rings
G014433