Toro Groundsmaster 4100-D 30411 Operator's Manual page 26

Figure 18
1. Castor wheel
2. Tensioning cap
3. Spacers
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 19
3. Push the castor spindle through the castor arm.
Install the shims (as originally installed) and the
remaining spacers onto the spindle shaft. Install the
tensioning cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from the
castor pivot arms (Figure 20).
5. Rotate tension rod to raise or lower pivot arm
until holes are aligned with selected height-of-cut
bracket holes in the cutting unit frame (Figure 20
and Figure 21).
4. Shims
5. Axle mounting holes
6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight)
to put tension on adjustment.
1. Castor pivot arm
2. Axle mounting holes
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 22).
26
Figure 20
3. Clevis pin and hair pin
cotter
4. Tension rod
Figure 21