Setup; Installing The Seat, Seat Belt, And Manual Tube; Greasing The Machine - Toro Groundsmaster 4100-D 30411 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Seat, Seat Belt,
and Manual Tube
Parts needed for this procedure:
1 Seat kit (obtain separately)
1 Seat suspension kit (obtain separately)
1 Manual tube
2 R-clamp
1 Seat belt
2 Bolt
2 Lock washer
Procedure
The machine is shipped without the seat assembly. The
Deluxe Seat, Model No. 30398, and Seat Suspension
Kit, Model No. 30396 or the Premium Seat, Model No.
Description
Seat kit (obtain separately)
Seat suspension kit (obtain separately)
Manual tube
R-clamp
Seat belt
Bolt
Lock washer
No parts required
Warning Decal
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Materials
Pre-delivery Inspection Sheet
CE certificate
Qty.
1
1
1
Install the seat, seat belt, and manual
2
tube.
1
2
2
–
Grease the machine.
Used only on machines outside the
1
U.S.A.
1
1
Read the manuals and training materials
1
before operating the machine. Use the
remaining parts for the installation of
1
attachments.
1
1
30622, and Premium Suspension Kit, Model No. 30621,
must be purchased and installed.
1. Mount the manual tube to the seat suspension with
the 2 R-clamps included in loose parts.
2. Install the seat belt to each side of the seat with a
bolt and lock washer, supplied in loose parts.
Important: Make sure that the seat switch wire
is connected to the seat switch connector on the
harness.
3. Slide the seat completely forward and backward to
ensure proper operation and that seat switch wires
and connectors are not pinched or do no contact any
moving parts.
2

Greasing the Machine

No Parts Required
Procedure
Before the machine is operated, it must be greased
to ensure proper lubricating characteristics; refer to
Greasing the Bearings and Bushings procedure of
14
Use