Panasonic AG-HVX200E Operating Instructions Manual page 107

RECORDING SETUP screen (continued)
Display
Item
mode
1394 TC REGEN (MCR/
P2 TAPE VCR)
TCG (Camera)
P2 TAPE (MCR/
VCR)
(DUB)
FIRST REC TC (Camera)
TAPE
(VCR)
(DUB)
TC PRESET (Camera)
P2 TAPE (MCR/
VCR)
(DUB)
Selects the time code used for recording the signal from equipment connected
to the 1394 terminal.
ON:
Records using the time code of the signal input through the 1394 terminal.
OFF:
Records using the time code set in TCG/FIRST REC TC.
• If you select ON here, this has priority over the settings in TCG/FIRST REC
TC.
• If there is no input to the 1394 terminal, the camera follows the settings in
TCG/FIRST REC TC.
Sets the mode in which you advance the time code.
FREE RUN:
The time code is advanced regardless of the operation mode.
Records in the dubbing mode in such a way that the time codes of the clips
on the P2 card are carried over. User information is also carried over.
• When setting a frame rate other than 25P during operation with the
720P/25PN format, the FREE RUN operation for the time code will not be
performed, and the REC RUN operation will be performed instead.
REC RUN:
The time code is advanced only when recording.
Selects the time code to be recorded when you start recording.
REGEN:
Regenerates the time code on the tape to continue recording.
PRESET:
The time code on the tape is not regenerated. The value you set in TC
PRESET is used as the initial value to record the time code. However, if you
perform subsequent shooting, the time code will always be regenerated.
Sets the initial time code. This is activated when you select PRESET in FIRST
REC TC.
Description of settings
indicates the factory setting.
ENGLISH
E-106