Setup; Loose Parts - Toro Reelmaster 2000-D 03431 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description
Wheel assembly
Lug nut
Flat washer
Capscrew
Locknut
Lift arm
Pivot rod
Capscrew, 5/16 x 7/8 in.
Lock washer
Lift chain
Clevis pin
Cotter pin
Thrust washer
Flat washer
Flange head capscrew
Spring
Vinyl sleeve
Spring shackle
Clevis pin
Cotter pin
Shackle
Spring anchor
Capscrew, 1/4 x 3/4 in.
Locknut
Key
Hydraulic reservoir plug
Danger decal
Warning decal
Danger decal
Instrument panel decal
Qty. Use
1
Installing the rear wheel
4
3
3 Mounting the carrier frames to the cutting units.
3
2
2
2
Installing the front lift arms (supplied with the
2
Lift Arm Kit)
2
4
4
3
Mounting the cutting units to the lift arms
3
(supplied with the Lift Arm Kit)
3
3
1
Installing the counterbalance springs (supplied
3
with the Lift Arm Kit)
6
6
2
2
Installing the counterbalance springs (supplied
with the 32" Cutting Unit Lift Arm Kit only)
4
4
2
1
Affix to inside of right hand panel housing for
1
European compliance.
1 Affix to skirt for European compliance.
1 Affix to battery for European compliance.
Affix to instrument panel for European
1
compliance.
13