Checking The Operation Of The Interlock Switches; Towing The Traction Unit - Toro Reelmaster 2000-D 03431 Operator's Manual

Danger
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others
and can cause property damage.
• Use a funnel and fill the fuel tank outdoors, in
an open area, when the engine is off and is cold.
Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add fuel
to the fuel tank until the level is 1 in. (25 mm)
below the bottom of the filler neck. This empty
space in the tank allows the fuel to expand.
• Never smoke when handling fuel, and stay away
from an open flame or where fuel fumes may be
ignited by a spark.
• Store fuel in a clean, safety-approved container
and keep the cap in place.
Checking the Operation of the
Interlock Switches
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
1. Be sure that the parking brake is set and all bystanders
are away from the area of operation. Keep hands and
feet away from the cutting units.
2. With the operator off of the seat, the backlap knob
rotated counterclockwise, the traction pedal in neutral,
parking brake engaged and the reel switch in the OFF
position, the engine should start. If either the traction
pedal is depressed or the reel switch is turned ON, with
the operator off of the seat, the engine should stop.
Correct the problem if it is not operating properly.
3. With the engine running, the operator off of the seat,
and the backlap knob rotated clockwise, the engine
should not stop when the reel switch is turned ON.
Correct the problem if it is not operating properly.
4. With the engine running, the operator off of the seat,
and the backlap knob rotated clockwise, the engine
should stop if the traction pedal is engaged. Correct the
problem if it is not operating properly.
5. With the operator on the seat, the engine running, and
the reel switch in the ON position, the dash indicator
light should be glowing and the reel motors turning
when the lift cylinder is fully retracted. As the lift
cylinder is extended, the light should go out and the reel
motors should stop turning. Correct the problem if it is
not operating properly.
6. With the operator on the seat, the engine must not start
with either the reel switch engaged or the traction
control engaged. Correct the problem if it is not
operating properly.

Towing the Traction Unit

In case of an emergency, the machine can be towed for a
short distance. However, we do not recommend this as a
standard procedure.
Important
Do not tow the machine faster than 2–3
MPH because the drive system may become damaged. If
the machine must be moved a considerable distance,
transport it on a truck or trailer.
1. Locate the bypass valve on the pump (Fig. 33) and
rotate it 90° (the bypass valve lever should be
horizontal when it is open).
Figure 33
1. Bypass valve
2. Before starting the engine, close the bypass valve by
rotating it 90° (the bypass valve lever should be
vertical when closed). Do not start the engine when the
valve is open.
28
1