Table of Contents
Advertisement
Install the Seat Belt
1. Install each end of the seat belt in the holes in the back
of the seat with (2) 7/16 x 20 – 1" lg. capscrews, 7/16
flatwashers and 7/16 lockwashers (Fig. 5). Tighten
securely. The latch side of the belt is to be mounted to
the left side of the seat.
Figure 5
1. Seat belt
Install the Manual Tube
1. Remove manual tube and R–clamps secured to seat
plate. Retain (2) mounting capscrews and flatwashers.
2. Loosely mount R–clamps to outer holes in left side of
seat with (2) capscrews and flatwashers previously
removed. (Fig. 6).
2
Figure 6
1. Manual tube
3. Install manual tube into R–clamps, insert manual into
tube and thread cap into tube (Fig. 6). Tighten
capscrews.
Activating and Charging the
Battery
Use only electrolyte (1.265 Specific Gravity) to fill battery
initially.
1
1
2. R–clamps
17
1. Remove the battery from the machine.
Important
Do not add electrolyte while the battery is in
the machine. You could spill it, causing corrosion.
2. Clean the top of the battery and remove the vent caps
(Fig. 7).
Figure 7
1. Vent caps
3. Carefully fill each cell with electrolyte until the plates
are covered with about 1/4 inch (6 mm) of fluid.
1
Figure 8
1. Electrolyte
4. Allow approximately 20 to 30 minutes for the
electrolyte to soak into the plates. Refill as necessary to
bring the electrolyte to within about 1/4 inch (6 mm) of
the bottom of the fill well (Fig. 8).
Warning
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
1
Advertisement
Table of Contents
