Table of Contents
Advertisement
Warning
• PTO universal shaft is attached to traction unit
frame. DO NOT ENGAGE PTO without first
removing universal shaft or coupling it to a
suitable implement.
Install the Steering Wheel
1. Remove steering wheel from seat plate. Remove cap
from steering wheel (Fig. 2).
2. Remove jam nut from steering shaft. Make sure foam
collar is on steering shaft (Fig. 2). Slide steering wheel
onto steering shaft.
3. Secure steering wheel to shaft with jam nut and tighten
it to 17–23 ft–lb.
4. Mount cover to steering wheel.
1
Figure 2
1. Steering wheel
2. Jam nut
4
2
3
3. Foam collar
4. Cover
16
Install the Handle to the Hood
1. Remove and discard the (2) screws and nuts securing
the hood cable bracket and to the underside of the hood
(Fig. 3).
1
Figure 3
1. Hood cable bracket
2. Mount the handle and the cable bracket to the hood with
(2) screws (Fig. 4).
2
Figure 4
1. Handle
Install the Seat
The Groundsmaster 3320 is shipped without the seat
assembly. The optional Seat, Model 30398 and the
Mechanical Seat Suspension Kit, Model No. 30312 or the
Pneumatic Seat Suspension Kit, Model No. 30313 must be
obtained and installed. Refer to the seat kit for installation
instructions.
Note: An Auxiliary Power Unit Kit, Model No. 30382,
must be obtained and installed before installing a
Pneumatic Suspension Seat Kit to the traction unit.
1
2. Hood cable bracket
Advertisement
Table of Contents
