Install Seat; Install Steering Wheel; Install Rear Weights - Toro ProLine 20 HP 30611 Operator's Manual

Install Seat

1. Position seat assembly onto seat plate aligning
mounting holes (Fig. 1).
2. Slide wire clamp over seat switch wire (Fig. 1).
3. Using left front hole, loosely secure wire clamp
and seat to seat base with capscrews and lock
nuts (Fig. 1).
4. Mount seat to seat base with (3) remaining bolts
and lock nuts.
5. Rout seat switch wire thru slot in seat plate and
plug connector onto seat switch (Fig. 1).
6. Tighten all lock nuts and check operation of seat.
7. Make sure wire harness is clear of lift arm and
all moving parts.
Figure 1
1. Seat plate
2. R-clamp
3. Seat switch wire
4. Seat switch connector

Install Steering Wheel

1. Move rear wheels so they point straight ahead.
2. Slide spacer and steering wheel onto steering
shaft aligning mounting holes. Check that logo
on steering cap points forward.
3. Secure steering wheel to shaft with roll pin
(Fig. 2).
2
1
Figure 2
1. Spacer
2. Roll pin

Install Rear Weights

1. Attach two (2) weights onto existing weight with
(4) 1/2 x 3-1/2" (89 mm) bolts, (4 ea.) 1/2"
washers, 1/2" lock washers and 1/2"nuts
(Fig. 3).
1
3
Figure 3
1. Weight
2. Bolt 1/2–13 x 3-1/2"
(89 mm)
Set-Up
3
3. Steering Wheel
2
3. Washer, lock washer and
nut
13