Install Steering Wheel; Install Seat - Toro 72071 Setup Instructions

Install Steering Wheel

1. Position front wheels straight ahead.
2. Remove logo cover by releasing (3) latches from
back side with screwdriver.
3. Line up center spoke toward the seat and
position the steering wheel onto shaft spline
(Fig. 3).
4. Secure steering wheel with lockwasher and nut
(Fig. 3).
Torque steering wheel nut to 50 ft-lbs (37 N . m).
5.
6. Snap logo cover into place (Fig. 3).
5
4
2
Figure 3
1. Center spoke
2. Shaft spline
3. Lock washer
1
3
2307
4. Nut
5. Logo cover

Install Seat

Note: If the seat is already installed, proceed
to Activate The Battery, page 4.
1. Install large ID spacer and shoulder bolts into
rear holes of seat (Fig. 4).
2. Position the seat onto the seat base by inserting
the two shoulder bolts through key hole
openings at the end of both slots (Fig. 4).
3. Locate small ID spacer between seat and seat
base, thread the knobs and flat washers into the
front holes in the seat (Fig. 4). Adjust the seat
and tighten the knobs.
4. Route seat switch wire and connector through
center opening in the seat base. Push the seat
switch connector fully into the wire harness
connector (Fig. 4).
5. Secure the seat switch wire cable to the fender
opening with wire clip (Fig. 4).
1
6
2
5
7
Figure 4
1. Seat
2. Spacer-small ID
3. Spacer-large ID
4. Bolt and flat washer
Set Up instructions
3
4
8
1271
5. Knob and flat washer
6. Wire and connector
7. Wire harness connector
8. Wire clip
3