Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note: Determine the left and right sides of the machine from the normal operating position.
1
Installing the Handle Assembly
Parts needed for this procedure:
1
Handle assembly
4
Flanged bolt, (3/8 x 1 inch)
4
Flange nut, (3/8 inch)
Procedure
1. Align handle with upper mounting holes in rear
frame (Figure 3).
2. Secure the handle at each upper mounting hole with
a flange bolt (3/8 x 1 inch) and flange nut (3/8
inch)(Figure 3).
Description
Flanged bolt, (3/8 x 1 inch)
Washer
Qty.
1
4
Install the handle assembly.
4
1
1
2
2
Install the fuel tank and shift lever plate.
4
1
2
2
-
Check and adjust the shift lever plate.
2
2
2
2
2
1
1
Read the Operator's Manual and watch
1
the training material before operating
the machine.
1
1
3. Select the low position for the lower mounting hole
(Figure 3).
4. Secure the handle at each lower mounting hole with
a flange bolt (3/8 x 1 inch) and flange nut (3/8
inch)(Figure 3).
Note: The handle position can be adjusted to match
the operator's height preference.
10
Use
Advertisement
Chapters
Table of Contents
