MAINTENANCE WORK ON THE CHASSIS
Removing the shock absorber
10.14
Installing shock absorber
10.15
Dismounting the start number plate
10.16
Installing the start number plate
10.17
x
–
Raise the motorcycle with a lift stand. (
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
700416-10
x
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
Screw, bottom shock absorber
700416-11
–
Remove the motorcycle from the lift stand. (
–
Remove screw
–
Remove screw
B00400-10
–
Position the start number plate with the drill holes onto the holding lugs
fender.
700413-01
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Position the brake line. Put the clamp on, mount and tighten screw
B00400-11
p. 27)
and lower the rear wheel with the swingarm as far as possible
, push splash protector
to the side and position the shock absorber. Mount and
.
.
and take off clamp.
. Remove the start number plate.
.
to the side, and remove the shock
M10
45 Nm
(33.2 lbf ft)
M10
45 Nm
(33.2 lbf ft)
p. 27)
M6
10 Nm (7.4 lbf ft)
.
34
of the