Maintenance Work On The Chassis; Raising The Motorcycle With A Lift Stand; Removing The Motorcycle From The Lift Stand; Bleeding Fork Legs - KTM 65 SX Owner's Manual

MAINTENANCE WORK ON THE CHASSIS

Raising the motorcycle with a lift stand

10.1
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.

Removing the motorcycle from the lift stand

10.2
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.

Bleeding fork legs

10.3

Cleaning the dust boots of the fork legs

10.4
–
Raise the motorcycle at the frame underneath the engine.
Lift stand (59229055000)
The tires should no longer be in contact with the ground.
–
Secure the motorcycle against falling over.
700405-01
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
the left side of the vehicle.
Info
Remove the plug-in stand before riding.
700406-01
–
Raise the motorcycle with a lift stand. (
–
Remove bleeder screws
Any excess pressure escapes from the interior of the fork.
–
Mount and tighten bleeder screws.
–
Remove the motorcycle from the lift stand. (
700417-01
–
Raise the motorcycle with a lift stand. (
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles from the fork tubes.
Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind the boots can start to leak.
700448-01

p. 27)
briefly.

p. 27)
of both fork legs downwards.

into the plug-in stand bracket on
p. 27)
27