Maintenance And Storage; Specifications - Black & Decker BDPS130 Instruction Manual

This will lubricate the piston and cylinder.
If your spray gun should require extra internal cleaning, it
may be necessary to disassemble it. (Fig. H).
If so the following action should be taken:
1. Remove the plug from the mains socket.
2. Remove paint container, pick up pipe and filter.
3. Take off the pump assembly.
4. Release the nozzle (H), valve (I), piston (M) and
spring (L).
5. Clean the cylinder (K) inside and all parts thoroughly
with solvent.
Important! keep the O rings on the cylinder away
from solvent which may cause the o rings corrputed.
6. Apply a few drops of light lubricating oil to the piston,
spring and cylinder.
7. Reassemble the spray gun.

MAINTENANCE AND STORAGE

Use only mild soap and damp cloth to clean the power
unit. Never let any liquid get inside the power unit; never
immerse any part of the power unit into a liquid.
Important! To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment (other
than those listed in this manual) should be performed
by authorized service centers or other qualified service
organizations, always using identical replacement parts.
The sprayer contains a washable/reuseable filter (Fig. V).
Check the filter before and after each use. If dirty, wash
with warm water and allow to air dry before re-installing or
replace if necessary.
f To check the filter, remove the filter cover by
loosening the two screws in the cover and pulling
the cover off the sprayer. Remove the filter as shown
in figure V and inspect. Replace filter and filter cover.
Snugly tighten screws. Never operate the sprayer
without the filter in place. Debris could be sucked in
and interfere with the function of the sprayer.
Make sure unit is clean and dry before storing. Store unit
indoors in a dry location. To prevent damage, wrap the
electrical cord so that it is not crimped during storage.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SPECIFICATIONS

Voltaje
Frequency
Current
Container capacity
ENGLISH • 25
BDPS130
120V 220V
60Hz 50-60Hz
0,8A 0,8A
800ml 800ml