Connecting Auxiliary Components; Reducing The Tv And Line Signal Levels - Pioneer XV-HTD530 Operating Instructions Manual

12 Additional information
Connecting auxiliary
components
This system has both stereo analog inputs
and outputs, as well as a coaxial digital input.
Use these to connect external components,
such as your VCR, MD or CD-R recorder.
Tape deck, etc.
AUDIO
INPUT
COAXIAL IN
LINE 2
XV–HTD530/630
• Connect the LINE 1 (IN) jacks to the
analog outputs of an external playback
component.
These include components such as a VCR or
cassette deck. Connect using RCA pin-plug
stereo cables. See also Reducing the TV and
line signal levels below.
• Connect the LINE 1 (OUT) jacks to the
analog inputs of an external recording
component.
These include components such as a
cassette deck, VCR, MD or another recorder
with analog inputs. Connect using RCA pin-
plug stereo cables.
90
En
AUDIO
OUTPUT
ANTENNA
FM
UNBAL
AUDIO
75
OUT IN IN
AM LOOP
L L
ANTENNA
R R
LINE 1 TV
• Connect the COAX IN (LINE 2) jack on
the rear panel to the coaxial digital output
of an external playback component.
These include digital components such as an
MD player, digital satellite, or a game system.
Connect using a coaxial digital cable (not
supplied).
Reducing the TV and line signal
levels
• Default setting: ATT 6dB
Some sources may produce a high signal
level which may produce unpleasant
distortion from the speakers. In such cases,
you may need to reduce the signal level of the
auxiliary source (connected to the TV or LINE
1 analog inputs) by switching on the
attenuator.
1 Switch the system into standby.
2 Press SYSTEM SETUP (SHIFT + HOME
MENU).
3 Use the (cursor left/right)
buttons to select 'TV ATT ?' or 'LINE1
ATT?', then press ENTER.
4 Use the (cursor up/down)
buttons to select 'ATT OFF', 'ATT 6dB' or
'ATT 10dB'.
If the ATT 6dB setting still results in distorted
sound, try the ATT 10dB setting.
5 Press ENTER to confirm.