KTM 950 Adventure 2005 Owner's Manual page 46

TROUBLE SHOOTING
TROUBLE
Engine does not rev up
Engine stalls while driving
High oil consumption
Headlight and position light fail Blown fuse
Flasher lights, brake light, horn
and multi-functional digital
speedometer fail
Time is not displayed or not
correctly displayed
The battery is discharged
No values are visible in the
multi-functional digital
speedometer display.
No speed display.
»
CAUSE
EPC valve is mounted incorrectly
and opens through vibrations
No fuel
Operating error
Fuse for fuel pump has blown
Engine oil level too high
Engine oil too thin (viscosity)
Blown fuse
Blown fuse, thus no continuous
power supply
The ignition (power consumer)
hasn't been switched off
The battery isn't charged by the
generator because
Blown fuse
Defective sensor cable or oxidized
socket connector.
REMEDY
Check the position of the EPC valve (near the oil dipstick), it
should not touch the frame
Refuel
Open fuel taps
Replace fuse FUEL PUMP
Check engine oil level when the engine is warm; correct if
necessary
Use thicker engine oil; see chapter „Engine oil"
Replace fuse H/L BEAM POSITION.
Replace fuse HORN BRAKELIGHT SPEEDO.
Replace fuse CLOCK and set the clock.
Recharge the battery according to the relevant instructions.
Remove left engine cowl and check brown cable connector
on the voltage regulator, voltage regulator and generator
should be checked by an authorized KTM workshop.
Replace fuse HORN BRAKELIGHT SPEEDO.
Check the pickup cable for damage, remove the left panel
and check the cable connector.
Contact an authorized KTM workshop.
45