KTM 950 Adventure 2005 Owner's Manual page 42

MAINTENANCE WORK ON CHASSIS AND ENGINE
1
1
2
6
4
5
9
Remove the 3 screws [1], lift the tank approx. 15 mm and carefully tilt to the
side. Disconnect the connector from the pickup cable (fuel level) and set the
tank down.
1
Remove the lower screw [2] on the right tank. Remove the HH screws and
take off the battery cover [3].
3
Remove the drain plug [4] on the oil tank and allow the oil to drain into a
receptacle. Remove the screws [5] and tilt the oil return valve [6] to the side.
5
Carefully pull the oil screen [7] out of the oil tank.
Thoroughly clean the drain plugs, the cover and both oil screens. Clean all
rubber seal rings and check for damage. Replace if necessary.
7
Mount the oil drain plug on the engine with a new seal ring and tighten to
20 Nm.
Slide the oil screen [8] into the guides in the oil pump housing with the TOP
8
mark facing up. Make sure the form ring is in place and mount the cap [9].
Tighten the screws to 10 Nm.
»
41