Samsung VCD9420S31 User Manual page 14

troubleshooting
pROblEM
Motor downs and does
not start.
suction force is gradually
decreasing.
cord does not rewind
fully.
Vacuum cleaner downs,
does not pick up dirt
Water leakage from the
dust bin.
Excessive water drops
from the inside of the
body.
dirty water comes out
of the top of the main
body
Water comes out from
the back cover.
low or decreasing
suction.
body overheating
static electricity
discharge
unpleasant smell during
vacuuming
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
14_ troubleshooting
Downloaded From Vacuum-Manual.com Manuals
sOluTiOn
• Check cable, plug and socket.
• Leave to cool.
• Check for blockage and remove.
• Pull the cord out 2~3m and push down the cord rewind button.
• Check hose and replace if required.
• Check rubber packing inserted tightly at the upper part.
• Check rubber packing to the lever at the bottom of the dust
bin.
• Some droplets on the inside body are to be expected.
Please dry the aqua cyclone fully.
• Check the filter is located properly.
• If the amount of water becomes excessive, check if water
inside dust bin is over the max line and make the water level is
under the max line.
• Check the water level of the aqua cyclone.
• Please operate the vacuum cleaner without the aqua cyclone
until water does not come out from the back cover.
• Please check filters. If required clean it as illustrated in the
instruction. If filters are out of conditions, change them to new
one.
• Please check filters. If required clean it as illustrated in the
instruction.
• Please decrease power suction.
• Please note that there may be a slight smell during vacuuming
when the cleaner is new (4-5 days).