Power Connector And Cable - HP ProBook 450 G2 Maintenance And Service Manual

Power connector and cable

Description
Power connector and cable
Before removing the power cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service doors (see
b. Keyboard (see
c. Hard drive
d. Optical drive
e. Top cover (see
f. Display assembly (see
Remove the power cable:
1. Disconnect the cable from the bottom of the system board (1).
2. Remove the cable from the clips built into the computer (2), and then lift the power cable from the
computer (3).
Reverse this procedure to install the power cable.
Battery on page
Service door on page
Keyboard on page 49)
(Hard drive on page 39)
(Optical drive on page
Top cover on page 58)
Display assembly on page
36).
37).
43)
88)
Component replacement procedures
Spare part number
767432-001
95