KTM 350 SX-F Owner's Manual page 77

SERVICE WORK ON THE ENGINE
–
Remove plug
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
–
Push the oil screen with O-rings on to a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
–
Mount and tighten screw plug
Guideline
B00330-11
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
B00329-11
–
Remove screws
B00331-11
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
B00332-11
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill oil filter with engine oil and place in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B00333-11
–
Remove the oil filler plug
engine oil.
Engine oil
B00327-11
with oil screen and the O-rings.
 
with the O-ring.

with the magnet and a new seal ring.

. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

with the O-ring from the clutch cover and fill up with

1.10 l (1.16 qt.)
M20x1.5 15 Nm
(11.1 lbf ft)
M12x1.5 20 Nm
(14.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 92)
formance
75
.

p. 92)