Harbor Breeze 40107 Installation Manual page 11

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
5. If you decided to cut back the lead wire in Step 4,
strip 1/2 in. of insulation from the end of the white
wire. Twist the stripped ends of each strand of wire
within the insulation with pliers (not included). Repeat
this step for black, blue and green wires.

Important: If you did not cut back the lead wires in
Step 4, Step 5 is not necessary and you
may proceed to Step 6.
6. Install the ball end of the downrod (A) into the opening
of mounting bracket (C). Align the slot in the ball with
the tab in the mounting bracket (C). Note: The rod
should not rotate if it is done correctly.
DANGER: Failure to align the slot in the ball
with the tab may result in serious injury or death.
Proceed to the Wiring on page 13.
5
6
11
A
Lowes.com/harborbreeze
C