Thermal Protection Mode icon will show on the top corner of these menus indicating that the
The user will be prompted to shut off the monitor within sixty seconds if the temperature
continues to rise after Thermal Protection Mode Step 2 has been enabled. If the system is not
manually turned off in sixty seconds, the touchmonitor will automatically turn off to prevent
permanent damage to the monitor. The table below shows the Auto Shut Off temperature.
Note: This will only enable in extreme conditions.
Portrait and Landscape Mode
Monitor Size
ET32/4201L
ET5501L/ET5501LT
ET7001L/ET7001LT
In the event that Thermal Protection Mode Step 1 or 2 has been enabled, the monitor will
resume full operational capabilities after the OSD temperature decreases to the values set forth
in the table below. These temperatures must be retained for at least five minutes.
Thermal Protect Mode is active
Thermal
Protection
Mode (°C) Step
Mode (°C) Step
1
60
56
50
Thermal
Protection
Auto Shut Off
2
Temperature (°C)
65
61
55
70
65
63
User Manual: Interactive Digital Signage
SW601990 Rev L, Page 24 of 37