Elo Touch Solutions ET3201L User Manual page 17

Parameter
Video Settings, Audio Settings, Color Settings and Other Settings can be selected
Main Menu
Video Source, Brightness, Contrast, Black Level, Sharpness and Aspect Ratio are
Video Settings
available in this menu.
Allows the user to switch between the available video sources.
Video Source
Allows the user to toggle the mute setting. Also, the volume of the internal speakers
or headphones can be adjusted.
Audio Settings
Default: Not Muted, Volume at 50
Displays the Color Adjust and Color Preference Menus
Color Settings
Allows HDMI video to be displayed on the monitor
HDMI
Allows VGA video to be displayed on the monitor
VGA Port
Allows DisplayPort video to be displayed on the monitor
DisplayPort
ECM DP – DisplayPort is the standard video output of Elo Computer modules. If
Elo Computer
HDMI video input is found, the video source can be switched.
Module
The monitor continually scans for active video from VGA, DisplayPort, HDMI, and
the Computer Module. This adjustment selects which of those input ports should be
displayed.
Video Source
If an Elo Computer Module or Intel OPS computer module has been detected,
video priority is given to the computer module before any of the external sources.
Increase/decrease monitor brightness.
Brightness
Default: 65
Increase/decrease monitor contrast.
Contrast
Default: 50
Allows user to change the H. position, V. position, Clock and Phase.
VGA Settings
If VGA is selected, the Auto-Adjust feature is available.
Adjusts sharpness of the displayed images.
Default: no sharpness adjustment
Sharpness
Sharpness function is disabled when the input source ratio is the same as the
panels native ratio
Switches the scaling method between Fill Screen and Fill to Aspect Ratio.
Default: Fill Screen
Fill Screen – Scales the X- and Y-dimensions of the input video (up or down as
needed) to the displays native resolution.
Fill Aspect Ratio – Assuming a landscape orientation and an input video with
aspect ratio smaller than 16:9, scales the Y-dimension of the input video (up or
down as needed) to the displays Y-resolution, and scales the X-dimension to
Aspect Ratio
maintain the aspect ratio (and fills the rest of the display with equal black bars on
the left and right).
Direct output - Input source is the same with output source and the image will be on
the center of the screen. No Scaling will occur.
Recalibration may be required when switching between these options.
The light sensor can be toggled on or off. When the light sensor is enabled, the
Light Sensor
brightness cannot be changed manually.
Automatically adjusts the system clock to the input analog VGA video signal,
affecting the H-position, V-position, Clock, and Phase menu items.
Auto Adjust
Not applicable when using HDMI video or the Computer Module.
- When the input source ratio is the same as the panel native ratio, this
function is disabled
Available Adjustment
User Manual: Interactive Digital Signage
SW601990 Rev L, Page 17 of 37