Joyner JNSZ1100SV Owner's Manual page 66

10. Water pump
Configuration diagram (the dismounting and assembling of the cylinder body
1.
should be done in the following procedures)
1"O" ring, non-reusable2 Oil pump body3 Weather seal
2. Dismounting
11.
12.
2.1. Dismounting and removal of O-shaped ring
Attention: These rings are not reusable.
2.2. Removing the three bolts and dismount the water pump principal body.
2.3. Removal of the dustproof sealing stripe
3. Clearing
3.1. Clearing of the mating surface of the water pump
4. Routine checks
4.1. Check to see if there are any deformation or damages
4.2. Use a hand wrench to see if the turning is OK, and if it is smoothly lubricated?
5. Installation
5.1. Install the dustproof sealing stripes
5.2. Install the water pump principal body
Tighten with a torque of 25±1.5N.m
5.3. Install the new O-rings
※:Non-reusable part
Unit: N*m (kg*cm)