KTM 450 EXC Owner's Manual page 59

12 SERVICE WORK ON THE CHASSIS
–
Mount and tighten screw
Guideline
Screw, top steering stem
K00092-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
K00090-11
(EXC Six Days)
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and
tighten screws
Guideline
Remaining screws, chassis
S00652-10
–
Position the fork legs.
Bleeder screws
B01598-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00139-10
–
Tighten screw
Guideline
Screw, top steering head
B01232-10

.
M8

.

but do not tighten yet.

.

are positioned toward the front.
Info
The rebound damping is located in the right fork leg REB (red adjusting
screw). The compression damping is located in the left fork leg COMP
(white adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.

.

.
17 Nm Loctite ®
(12.5 lbf ft)
M8 17 Nm
(12.5 lbf ft)

.
M6 10 Nm
(7.4 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm
(8.9 lbf ft)
57
243™