Volvo S 90 Owner's Manual page 371

Front bumper: Remove the cover. Rear bumper: Remove the cover by pressing
the mark in the lower left corner with a finger
and folding out the opposite side with a coin,
etc.
> The cover folds out and can then be
removed.
4. Screw the towing eyelet into place, first by
hand and then using the tire iron, etc. until it
has been screwed in as far as possible.
After use, the eyelet should be removed and
returned to its storage location.
Reinsert the cover into the bumper.
STARTING AND DRIVING
CAUTION
In certain conditions, the towing eyelet
may be used to pull the vehicle onto a
flatbed tow truck.
•
The vehicle's position and ground clear-
ance determine if it can be pulled up onto
a flatbed tow truck using the towing eye-
let.
•
If the angle of the tow truck's ramp is too
steep or the ground clearance under the
vehicle is insufficient, damage could
occur by attempting to pull the vehicle
using the towing eyelet.
•
If necessary, lift the vehicle using the tow
truck's lifting device.
WARNING
No person or object should be behind the tow
truck while the vehicle is being pulled up onto
the flatbed.
Related information
•
Towing recommendations (p. 370)
369