12
SERVICE WORK ON THE CHASSIS
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the adjusting screws
left and right chain adjusters
marks
Info
The upper part of the chain must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
K00435-11
Guideline
Nut, rear wheel spindle
Finishing work
–
Check the chain tension. (
–
Remove the rear of the motorcycle from the lifting gear. (
.
.
on the left and right so that the markings on the
are in the same position relative to the reference
. The rear wheel is then correctly aligned.
.
are fitted correctly on adjusting screws
.
p. 89)
left and right.
5 mm (0.2 in)
M25x1.5
90 Nm
(66.4 lbf ft)
p. 83)
92
.