14
WHEELS, TIRES
–
Engage the thurst bearing of brake caliper support
–
Lift the rear wheel into the swingarm, position it, and insert the wheel spindle.
The brake linings are correctly positioned.
–
Place the chain on the sprocket.
–
Position chain adjuster
Info
Mount the left and right chain adjusters in the same position.
–
Make sure that chain adjusters
nut
.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
–
Position wheel speed sensor
Guideline
K00435-10
Remaining screws, chassis
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
Finishing work
–
Check the chain tension. (
–
Remove the rear of the motorcycle from the lifting gear. (
. Mount nut
, but do not tighten it yet.
are fitted correctly on the adjusting screws. Tighten
M25x1.5
in the drill hole. Mount and tighten screw
M6
p. 89)
and the swingarm.
.
90 Nm
(66.4 lbf ft)
.
10 Nm (7.4 lbf ft)
p. 83)
121