Table of Contents
Advertisement
Replacing the Front Bezel
1.
Follow the instructions in "Before You Begin" on page
2.
Align the front bezel with the front of the chassis.
3.
Replace the three screws on the right side that secure the front bezel to the
chassis.
4.
Lay the chassis on its side.
5.
Connect the front-bezel cables to the connector on the master I/O board.
6.
Replace the seven screws that secure the front bezel to the chassis.
7.
Replace the right side-panel(s) (see "Replacing the Right Side-Panel(s)" on
page 81).
8.
Replace the drive-bay shroud (see "Replacing the Drive-Bay Shroud" on
page 19).
9.
Close the PCI shroud (see "Closing the PCI Shroud" on page
10.
Replace the left side-panel (see "Replacing the Left Side-Panel" on page
11.
Connect your computer and devices to electrical outlets and then turn
them on.
6.
18).
11).
CHAPTER 18: FRONT BEZEL
092
/
092
Advertisement
Table of Contents
