Quick Start Function - Canon HR10 Instruction Manual

• You can also use the T and W buttons
on the wireless controller or the LCD
panel. The zoom speed will be the same
as with the camcorder or fixed at
[ SPEED 3] (when [
selected).
• When set to [ VARIABLE], the zoom
speed will be faster in record pause
mode.

Quick Start Function

QUICK START
When you press
camcorder enters the
mode. In standby mode the camcorder
consumes only about half the power
used when recording, saving energy
when you are using a battery pack.
Additionally, when you press
QUICK START
again the camcorder is
ready to start recording within approx.
1 second, ensuring you do not miss
important shooting opportunities.
POINTS TO CHECK
1 QUICK START
Press
The standby lamp flashes at first
while the camcorder is preparing and
VARIABLE] is
the
standby
( 26)
firmly.
then stays on when it enters the
standby mode.
2
When you wish to resume
recording, press
again.
Within approx. 1 second, the
camcorder is ready in record pause
mode.
NOTES
• When you wake up the camcorder from
standby mode, the following settings
will be changed automatically:
- Manual focus returns to automatic
focus (AF).
- Manual exposure adjustment returns
to automatic exposure.
- Zoom position returns to full wide
angle W.
• The camcorder will shut off if left in
standby mode for 10 minutes,
regardless of the [POWER SAVE] setting
( 52). You can select the length of
time until shut-off with the [
OFF] setting ( 53).
To restore the power if the camcorder
shut off, slide the
MODE and release it, or move the
switch to
again.
• If you perform any of the following
actions while in standby mode (while the
standby lamp is on), the camcorder will
return to record pause mode.
- Open the disc compartment cover.
- Change the position of the
switch.
- Slide the
QUICK START
STANDBY
switch toward
and back to ON
/
switch toward MODE.
39