Canon HR10 Instruction Manual page 108

Additional Information
Message
DISC FULL
TASK IN PROGRESS
DO NOT DISCONNECT THE
POWER SOURCE
NO CARD
NO IMAGES
CARD ERROR
CARD FULL
THE CAMCORDER IS SET TO STILL
IMAGE MODE
NAMING ERROR
TRANSFER ORDER ERROR
TOO MANY STILL IMAGES
DISCONNECT USB CABLE
Direct Print Related Messages
About Canon PIXMA/SELPHY DS Printers: If the printer's error indicator flashes or an error
message appears on the printer's operation panel, refer to the printer's instruction manual.
Message
PAPER ERROR
NO PAPER
PAPER JAM
108
The disc is full (" END" appears on the screen). Delete some recordings
(DVD-RW in HD quality, or SD quality (VR mode)) to free some space or replace
the disc.
The camcorder is updating the disc. Do not disconnect the compact power
adapter or remove the battery pack.
There is no memory card in the camcorder.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or display the
image. If after the message disappears
following: Turn off the camcorder; remove and reinsert the memory card and
set the camcorder back to
If turns back to green you can resume recording/playback. Otherwise,
initialize the memory card. (Doing so will erase all the still images on the
memory card.)
Memory card is full. Erase some images to free some space or replace the
memory card.
START/STOP
You pressed while recording still images (
The folder and file numbers have reached their maximum value. Set the
[FILE NOS.] option to [RESET] and erase all the images on the memory card or
initialize it.
You attempted to set more than 998 transfer orders. Reduce the number of
still images marked with transfer orders.
Disconnect the USB cable and decrease the number of still images on the
memory card to fewer than 1,800. If a dialog appeared on the computer
screen, close it and then reconnect the USB cable.
There is a problem with the paper. The paper is not correctly loaded or the paper size is
wrong.
Alternatively, if the paper output tray is closed, open it to print.
Paper is not correctly inserted or there is no paper.
The paper jammed during printing. Select [STOP] to cancel printing. After removing the
paper, set some paper again and retry printing.
Explanation
appears in red, perform the
mode.
Explanation
43
–
34
–
84
77
mode). –
–
100
–