Part Names of the Projector
Front/Top
Remote Sensor
Ventilation (outlet)
Heated air is ex-
hausted from here.
Adjustable Tilt Foot Lever
*
Rear
Terminal Panel
AC Input
Connect the supplied power
cable's three-pin plug here, and
plug the other end into an active
wall outlet. (→ page 17)
Downloaded From projector-manual.com NEC Manuals
Zoom Lever
(→ page 23)
Focus Ring
(→ page 23)
(→ page 8)
Lens
(→ page 22)
Adjustable Tilt Foot
(→ page 22)
This security slot supports the MicroSaver ® Security System.
(→ page 6)
Monaural Speaker (7W)
Controls
(→ page 5)
Lens Cap
Rear Foot
(→ page 22)
4
1. Introduction
Ventilation (inlet)
Built-in Security Slot (
)*
Security chain opening
Attach an anti-theft device.
The security chain opening accepts
security wires or chains up to 0.18
inch/4.6 mm in diameter.
Lamp Cover
(→ page 71)
Ventilation (inlet)
Spacer (black rubber)
To fine-adjust the height of the rear
foot, remove the spacer and rotate
the rear foot to the desired height.