Troubleshooting; Indicator Messages - NEC V300X User Manual

7. Appendix

1 Troubleshooting

This section helps you resolve problems you may encounter while setting up or using the projector.

Indicator Messages

Power Indicator
Indicator Condition
Off
Blinking light Green
Steady light Green
Orange
Red
Status Indicator
Indicator Condition
Off
Blinking light Red
Green
Steady light Green
Orange
Lamp Indicator
Indicator Condition
Off
Blinking light Red
Steady light Red
Green
Over-Temperature Protection
If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp
Should this happen, do the following:
Downloaded From projector-manual.com NEC Manuals
Projector Condition
The power cable is unplugged.
0.5 sec On, The projector is getting ready to turn on.
0.5 sec Off
2.5 sec On, Off Timer is enabled.
0.5 sec Off
The projector is turned on.
[NORMAL] is selected for [STANDBY MODE]
[POWER-SAVING] is selected for [STANDBY
MODE]
Projector Condition
Normal or Standby ([POWER-SAVING] for
[STANDBY MODE])
1 cycle (0.5 sec Lamp cover error or lamp housing error
On, 2.5 sec Off)
2 cycle (0.5 sec Temperature error
On, 0.5 sec Off)
4 cycle (0.5 sec Fan error
On, 0.5 sec Off)
6 cycle (0.5 sec Lamp error
On, 0.5 sec Off)
Re-firing the lamp (The projector is cooling
down.)
Standby ([NORMAL] for [STANDBY MODE])
Cabinet button is locked
CONTROL ID error
Projector Condition
Normal
Lamp has reached its end of life. Lamp replace-
ment message will be displayed.
Lamp has been used beyond its limit. The projec-
tor will not turn on until the lamp is replaced.
[ECO MODE] is set to [ON]
Wait for a moment.
Replace the lamp cover or lamp housing cor-
rectly.
The projector is overheated. Move the projector to
a cooler location.
Fans will not work correctly.
Lamp fails to light. Wait a full minute and then
turn on again.
The projector is re-firing.
Wait for a moment.
–
You have pressed cabinet button when Cabinet
Button is locked.
Remote control ID and projector ID are not
matched.
Replace the lamp.
Replace the lamp.
73
Note
Note
Note