Table of Contents
Advertisement
1. Turn off the printer.
2. Turn over the Label Printer and
remove the back cover while pressing
down on its lock as shown in the
illustration.
3. Load batteries into the battery
compartment.
Be sure to use alkaline batteries.
Make sure the plus (+) and minus
(–) ends of the batteries are facing
correctly when you load them.
4. Replace the printer cover.
Turning the Printer On and Off
Press
to turn the printer on and off.
SE L ECT
TAPE
When you turn on the printer, the tape width selection screen will appear.
Use
and
to select the tape width you will use, and then press OK.
Initializing Memory
Important!
If you are using the Label Printer for the fi rst time, you should Initialize it
fi rst.
Note that initializing memory will delete all currently stored data. You
should only initialize memory before using the printer for the fi rst time.
To initialize memory
1. Make sure that printer power is off.
2. While holding down the
and
A message appears to confi rm whether you want to initialize memory.
I N I T I A L I ZE ?
3. Release the
,
, and
keys.
4. Press OK to initialize the Label Printer.
• This displays the language setting screen.
• Press
to abort the reset operation
5. Use
and
to select the display language you want and then press OK.
• This displays the length unit setting screen.
6. Use
and
to select the length unit you want and then press OK.
• This displays the tape width selection screen.
7. Use
and
to select the width of the tape you will use and then press
OK.
W
I DTH
keys, press
to turn power on.
OK / CANCEL
7
EN
Hide quick links:
Advertisement
Table of Contents
