Part 9 Memory - Casio KL-130 User Manual

Part 9 Memory
Your printer has memory for up to 10 text segments and 10 bar codes.
Important!
Be sure to keep written backup copies of all important data.
To store text
1. Input the text you want to store.
2. Press .
3. Use and to select STORE.
4. Press OK.
5. Input the name you want to assign to the text segment and then press OK.
You can input up to 10 characters for the name.
6. Use and to select the location where you want to store the text and
then press OK.
<NO DATA> will be shown when a memory location does not contain
any text.
7. Press OK to store the text or
storing anything.
• If there is already text stored at the location, the message "OVERWRITE?
OK/CANCEL" will appear when you press OK. Press OK again to replace
the existing text with the new text, or
To store a bar code
1. After creating the bar code you want, press OK.
If you want to store the bar code you are creating, press
advance to step 3 of this procedure.
2. Use and to select the bar code size you want and then press OK.
3. Use and to select STORE and then press OK.
4. Input the name you want to assign to the bar code and then press OK.
You can input up to 10 characters for the name.
5. Use and to select the memory location where you want to store the
bar code and then press OK.
<NO DATA> will be shown when a memory location does not contain a
bar code.
20 EN
to abort the store procedure without
to cancel the store operation.
and then
6. Press OK to save the bar code or
If the selected memory location already contains bar code data,
pressing OK will cause the message "OVERWRITE? OK/CANCEL"
to appear on the display. Press OK to replace the data at the selected
memory location with the new data, or
To recall text
1. While the input screen is on the display, press
2. Use and to select RECALL.
3. Press OK.
4. Use and to select TEXT and then press OK.
to select the text you want to recall and then press OK.
5. Use and
This will cause the message "RECALL? OK/CANCEL" to appear on the
display.
6. Press OK to recall the text or
This recalls the text.
Note that recalling text replaces anything that is currently on the input
display.
To delete stored text
1. While the input screen is on the display, press
2. Press and to select DELETE.
3. Press OK.
to select TEXT and then press OK.
4. Use and
5. Use and to select the text you want to delete and then press OK.
This will display the message "DELETE? OK/CANCEL" to confi rm.
6. Press OK to delete the text.
To recall or delete a saved bar code
Perform the same steps as those under "To recall text" and "To delete stored
text", selecting BAR CODE in place of TEXT in step 4.
to cancel the save operation.
to cancel the save operation.
.
to cancel the recall operation.
.