Liquid Vacuum Operation - Vacmaster VQ1530SFDC Operator's Manual

LIQUID VACUUM OPERATION

1 2
3 4 5
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS,
OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM
TOXIC MATERIALS.WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET,
MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET AND DRY
VACUUM CLEANER.
5.1. Verify that the power cord is disconnected from the power socket. Verify that the container is
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING. OPERATING
INSTRUCTIONS – WET VACUUMING.
5.4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
5.6. After use, empty the tank and dry.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
You will notice an increase in motor noise. When this happens, turn off the machine, disconnect
from power supply, and drain the liquid into a suitable receptacle or drain. To continue vacuuming,
from power supply. Empty the container, clean and dry the inside and outside before storage.
REMEMBER!
installed before dry vacuuming again.
10