Changing Channels / Volume - Hisense 40H5B User Manual

7. Select Network : Connect your TV to access the
network.
5.Network
Select Access Point
Auto Scan
Manual Input
Manually input the configurations of
Access Point in your wireless network
Previous
"Network Connection" and "Network Setup".
8. Input Source.
Press [▲/ ] to select the TV signal source.
6. Input Source
Input Source
TV
AV
Component
HDMI1
HDMI2
Previous
Choose from one of the following sources below and then
move to the next screen.
• TV
• AV
• Component
• HDMI1
• HDMI2
• HiMedia
Note: If you use an antenna to receive channels, then
you must complete the first-time setup menu in order to
run a channel scan.
Congratulations! You have completed the setup menu.
Press the [OK] on your remote to select [GO] if you are
okay with the selections that appear on the screen.
Otherwise, navigate to the [Previous] button on the screen to
change your selection.
Basic Features
Next: Channel Search
Next
Press [RED] to skip
Next

Changing Channels / Volume

1. Press the [CH /V] (or [CH +/-]) on the TV/remote control
to change the channel.
2. Press the [VOL
control to adjust the volume.
3. Press the numeric buttons on the remote control to
display the corresponding channels.
NOTE
Changing the channels can also be achieved by directly
entering the channel number using the numeric keys on
the remote control. If you are entering a two or three digit
channel number, the time between key presses should be
less than 3 seconds.
10
/V] (or [VOL +/-]) on the TV/remote