Selecting Language - Furuno NX-300-D Operator's Manual

2.8 Selecting Language

You can select language displayed on the NX-300. Languages are English, French, German,
Italian, Spanish, Dutch, Danish, and Portuguese.
1. Press the [MENU] key to open the main menu.
2. Press to select LANGUGE.
3. Press the [ENT] key. The following menu appears. (ENG: English, FRA: French, GER:
German, ITA: Italian, SPA: Spanish, DUT: Dutch, DEN: Danish, POR: Portuguese)
4. Use the Omnipad to select language desired.
5. Press the [ENT] key to register your selection and press the [MENU] key to close the menu.
2.9 Display Messages
The NX-300 automatically saves and stores up to 132 received messages (However, the
memory capacity is limited to 28,000 characters). If memory of the NX-300 is full, messages are
deleted on order of time.
1. Press the [DISP] key to show the received messages log. Messages (numbers) are
arranged in the order received from latest to earliest, Left to right.
The latest
message
For A, B or L type
message
2. Operate the Omnipad to select the message to display. If more than 15 messages are
saved, the scroll bar appears at the left side of the display. Press
display.
3. Press the [ENT] key to display the message selected.
Note: If you want to see the received frequency (518 kHz or 490 kHz) also, change the window
mode as shown on page 4-2.
Figure 2-20 LANGUAGE menu
Figure 2-21 Received messages log
Unread message
D type message
or to scroll the
2-9