Setting Upscale/Downscale Tc Burnout - Omega RD260A User Manual

7.4 Setting Upscale/Downscale TC Burnout

The purpose of the following setting is to specify where the pens will move in the case
of a TC-burnout. You can choose from moving to the right (UP) or to the left (DOWN).
This is common for every channel. You can select ON or OFF for each channel.
The initial value is 'UP', and 'OFF' for every channel.
SETTING PROCEDURE:
Enter the SET UP mode by turning 'ON' the power while pressing and holding the [CH
UP] ( ENT) key until the SET UP display appears.
Use the [ ] key to select the display [
Use the [ ] key to select the display [
Select [ ] or [ ] using the [
The display [ ] appears.
This burnout processing is ON/OFF selectable per channel.
Press the [ENT] key.
Use the [ ] key to select the display [
Select the channel No. using the [
processing. Then press the [ENT] key.
Select 'ON' or 'OFF'. Then press the [ENT] key. The display [
Before leaving the SET UP mode, you have to store your new settings. Use the [
to select the [ ] display, and press the [ENT] key.
Select [ ] to keep your new settings or [
press the [ENT] key. After a few seconds, the OPERATION mode will appear.
7.4 Setting Upscale/Downscale TC Burnout
]. Press the [ENT] key.
]. Press the [ENT] key.
] key. Press the [ENT] key.
]. Press the [ENT] key.
] key for which you want to specify this burnout
] to abort the settings, and
] appears.
] key
7 - 5