Draytek Vigor2925 Quick Start Manual page 9

Right LED
(Green)
Left LED
LAN1~LAN5
(Green)
Right LED
(Green)
Switch on Rear Side
Interface Description
Factory Reset Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and
keep for more than 5 seconds. When you see the ACT LED begins to
blink rapidly than usual, release the button. Then the router will
restart with the factory default configuration.
USB1~USB2 Connector for a USB device (for 3G/4G USB Modem or printer or
Environmental Thermometer).
WAN1 Fiber connection (100Mbps) for accessing the Internet.
(for Vigor2925F)
WAN1~WAN2 Connecter for local network devices or modem for accessing
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
4
(For Vigor2925L only)