DFI G586OPB User Manual page 40

PCI/ISA System Board
3. Position the CPU above the ZIF socket. Make sure
pin 1 of the CPU is aligned with pin 1 of the socket.
Lower the chip until the pins are inserted properly in
their corresponding holes. Remember that very little
force is needed to install the CPU. If the CPU will
not easily insert, please verify you have pin 1 of the
CPU aligned with pin 1 of the socket. Applying too
much pressure can damage the CPU or the socket.
Positioning the CPU Above the ZIF Socket
4. Push the handle down until the handle locks into
place. The top plate will slide forward. You will feel
some resistance as the pressure starts to secure the
CPU in the socket. This is normal and will not
damage the CPU. However, if the handle is not
completely closed, damage to the CPU and/or
system board may result.
2-32 u Installation Overview