Installing The Blower - Napoleon HD35NT-1 Installation And Operating Instructions Manual

40
7.2

INSTALLING THE BLOWER

Open the blower kit and
A.
remove the thermal disc from
EN
the bracket. Remove the
speed control bracket from
the burner base assembly,
install the thermal disc and
speed control switch onto the
speed control bracket and
reattach to the burner base.
Reverse procedure to
B.
re-assemble.
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must
be electrically connected and grounded in accordance with local codes.
In the absence of local codes, use the current CSA C22.1 Canadian
electrical code in Canada or the ANSI / NFPA 70 national electrical code
in the United States.
Drywall dust will penetrate into the blower bearings, causing irreparable
damage. Care must be taken to prevent drywall dust from coming into
contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty policy. To safely install the fan,
turn off the electricity first.
Slide the vibration reducing pad (A) into the clip (C) and up against the
threaded stud (B) at the other end. The blower must be
able to be positioned entirely onto the pad.
Attach the connectors from the black and white wires
to the thermal disc.
Attach the connectors from the black and red wires
to the blower.
Plug the harness cord into the receptacle.
Because the blower is thermally activated, when turned on, it will automatically start approximately 10 minutes
after lighting the fireplace and will run for approximately 30-45 minutes after the fireplace has been turned off.
Use of the fan increases the output of heat.
W415-1566 / 11.05.15
SPEED CONTROL
BRACKET
BLOWER
GASKET
B
THERMAL
DISC
SPEED
CONTROL
SWITCH
BLOWER
white
THERMAL
SWITCH
A
51.2
VARIABLE
SPEED
KNOB
VARIABLE
SPEED
SWITCH
C