Table of Contents
Advertisement
1
2
2
4
3
BLEEDING THE OIL SYSTEM
To facilitate bleeding of the oil system, we have added a hose connection
piece and a plastic hose to the set of tools. Take an empty oil can (1 liter)
and drill a 7 mm-diameter hole into the lid. Screw the hose connection
piece into the lid from the outside, and secure it from the inside with the
M8 hexagon nut.
Slip the plastic hose onto the hose connection piece, and you will have your
filling tool.
Fill 0.6 liters of engine oil into the can and remove the plug
steering head. Introduce the plastic hose into the vent hole
liters of engine oil into the frame's front tube. Remove plastic hose, start
engine, and let it idle (approx. 20 seconds) until oil escapes at the hole
As soon as oil starts to escape, turn off the engine, and mount the plug
together with the gasket.
Allow the engine to run until warm. Then, turn off the engine, and place
the motorbike on a flat, level surface in an upright position (center stand).
Wait for 5 minutes. Unscrew and remove the oil dipstick, and wipe it clean
B
with a cloth.
SCREW THE DIPSTICK IN ALL THE WAY AND REMOVE IT AGAIN.
The oil level should be between the two marks on the oil dipstick, however,
it must never rise above the MAX mark.
Otherwise, engine oil would get into the air filter box by way of the engine
venting system.
Add engine oil, if necessary.
– I
NSUFFICIENT OIL OR POOR QUALITY OIL RESULTS IN PREMATURE WEAR OF THE ENGINE
– C
HECKING THE ENGINE OIL LEVEL WHEN THE ENGINE IS COLD RESULTS IN A FALSE REA
DING ON THE OIL DIPSTICK AND THEREFORE AN INCORRECT OIL LEVEL
– D
O NOT OVERFILL THE ENGINE CASE
– D
O NOT UNDERFILL THE ENGINE CASE
Finally, check oil system and engine for leaks.
NOTE:
D
ISPOSE OF USED OIL PROPERLY
DISPOSED OF IN THE SEWAGE SYSTEM OR IN THE OPEN COUNTRYSIDE
1.000.000
TAMINATES
Changing oil filter *
Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
3
stopper roll so that the oil filter cover is more accessible. Remove banjo
2
bolt
and the three screws. Remove oil filter cover
filter housing, oil filter cover, and sealing surfaces. Check oil duct in oil filter
cover if clogged.
Check the O-ring
damaged. Press the O-ring into the groove of the filter cover. Fit new oil
5
filter
with rubber gasket on the fitting in oil filter cover and mount cover
with filter. Mount three screws and tighten with 5 Nm (4 ft.lb). Mount
hollow screw with seal rings and tighten with 15 Nm (11 ft.lb). Start engine
and check oil system for leakage.
5
CAUTION
!
.
.
! U
NDER NO CIRCUMSTANCES MAY USED OIL BE
.
LITER WATER
4
for damage. O-rings need not be replaced unless
1
next to the
B
, and fill 0.6
B
.
31
!
.
-
.
. 1
-
LITER OIL CON
3
and oil filter. Clean
Hide quick links:
Advertisement
Table of Contents
