Krups xp7225 ESPRESSERIA AUTOMATIC Manual page 10

FALC DISP USA dernière version 7220.qxp
Press the on/off button , wait for the end of pre-heating and perform a rinsing operation if you wish.
The selection menu will
be displayed.
To stop coffee flowing into the cup, you can either again press "OK" or turn the rotating button to reduce
volume.
P P l l e e a a s s e e n n o o t t e e : : The ground coffee is first moistened with a little hot water after the grinding stage. This is called
"pre-brewing" and it optimizes the brewing process by ensuring that the grounds are evenly wet.
A few moments later, the full brewing cycle begins.
There is a temperature setting function to control how hot your coffee is (see Settings).
You can use your machine to make 2 cups of coffee or espresso by cycling the machine twice. Remember not to remove
the cups after the first cycle.
Put two cups under the
coffee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
If the drip tray is full or the water tank is empty after preparing the first coffee, the second cycle will not function.
You will then have to restart your second cycle after you have emptied the tray and refilled the water tank.
Steam is used to froth milk (for cappuccino / latte) but can also be used to reheat other liquids. As you need a higher
temperature to produce steam than to make an espresso, the machine runs an additional pre-heating phase for steam.
7/06/06
Put a cup under the coffee
outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
TWO-CUP FUNCTION
x 2
Select your drink and confirm
by pressing the OK button
twice. A message will appear
to tell you that you have
chosen two cups.
USING STEAM
When the screen displays the selection menu, press the "steam" key
inform you that the machine is being pre-heated. Once the pre-heating phase has been
completed, a message will ask you to place a container under the steam nozzle. Press the
"steam" key again to start generating steam. A little water will be produced first and
then steam will start. Use the same key to stop steam generation.
9
9:56 Page 9
Use the rotating button You can change the
to select your choice volume of water at any
and confirm by pressing time using the rotating
the OK button. knob.
The machine will
automatically
sequence through
two complete cycles.
. The screen will