Samsung XRN-2010 User Manual page 36

menu setup
Connecting the iSCSI
If you connect the NVR with an iSCSI device, you can search, connect and disconnect the iSCSI device.
• iSCSI Usable Name : It displays the name of iSCSI in compliance with the iSCSI protocol format.
• Capacity : It displays the currently used amount/total capacity of iSCSI devices.
• Status : Displays the status of an installed iSCSI device.
List of products supported
Promise Technology vessRAID 1740i / 1840i / 2600i 1ea JBOD 3ea
Adding an iSCSI device automatically
1. In the iSCSI window, click on the <Add Automatically> button.
2. On the Auto Add screen, enter the IP address and the connecting port, and click <Search>.
3. In the <iSCSI Usable Name> list, click on a device to add.
4. After entering ID/password, click on the <OK> button.
Adding an iSCSI device manually
1. On the iSCSI screen, click <Add Manually>.
2. On the Manual Add screen, enter the IP address, the connecting port, the ID and the password, and click
<OK>.
Canceling registration of iSCSI devices
1. In the <iSCSI Usable Name> list, select an iSCSI device to delete.
2. Click on the <Delete> button to launch the Delete window.
3. If you click <OK>, the iSCSI device is removed from the list.
36_ menu setup
`
M
For iSCSI equipment, use network port 2.
`
When using a hub to connect an iSCSI device with NVR, make sure to use the GIGA hub and to use an independent network
to save data normally.
`
When you perform single directional CHAP authentication in vers. RAID, an iSCSI device in compliance with the NVR, you
need to use the iSCSI Manual Add function to make a connection to iSCSI.
`
If multiple NVRs try to access a single iSCSI device, it can cause a problem.
`
When the NVR is connected to an iSCSI device, if you change the iSCSI equipment setting, a problem can occur.
`
A HDD to be mounted in vess RAID should be listed in the RAID compatibility
`
It is recommended that you configure each volume for an iSCSi device with a maximum of 16 HDD.
`
When you register an iSCSI device in the NVR for the first time, you need to format it first.
`
The iSCSI lun mapping function is supported.
`
If you activate the lun mapping function in the iSCSI device, the lun can only be connected to an NVR which is mapped.
list.