Samsung XRN-2010 User Manual page 10

installation
4. Connect the cable to the HDD by matching the HDD
SATA/power cable number to the HDD position
number on the bracket.
`
For the HDD location number on the bracket, please refer to
the figure below.
5. Mount the bracket on which an additional HDD is
mounted on the NVR, secure it with screws and
connect the SATA/power cable to the connector on
the main board by matching the number.
`
For the connector numbers, please refer to the figure below.
6. Check for any problems in the connection terminal
and the wiring in the product, close the cover and fix
it with screws.
10_ installation
Bracket
ALARM
1 2 3 4 5 6 IN ALARM RESET
7 8 G
NETWOR
K 2
NO NC NO
COM COM COM NO NO G RS-232C
1 2 3 COM eSATA
4 ALARM OUT NETWOR
K 1 AUDIO
OUT
VGA OUT
HDMI
USB CONSOLE
ALARM ALARM
1 2 3 4 5 6 IN 7 8 RESET
G
NETWORK 2
NO COM NC NO NO NO VGA OUT
1 COM COM COM G
2 3 4 ALARM eSATA NETWORK
OUT 1 AUDIO
OUT
RS-232C
HDMI
USB
CONSOLE
7
5
8
3
6
1
4
2
8
6
7
5
4 3
2 1
USB
How to install an HDD in XRN-2011
1. Open the front cover and check the HDD installation
bracket.
`
J
Release the USB connection before opening the front
cover to prevent damage to the USB port.
2. Push the latch to the right and remove the HDD
bracket.
`
J Take care not to scratch your hands when removing the
HDD bracket.
3. Align and insert HDD into the bracket home. After
inserting one side, push and insert the other side
slightly.
4. Align the bracket with the HDD installed with the
enclosure latch, and push the bracket in the direction
of the board.
`
J Push it until you hear the latch lock sound. If the HDD is
not completely connected, it may be detected.